Invicta™ Throttle Footrest
Footrest Installation
Updated on September 21, 2022
Box content:
• Throttle Footrest
• Three (3) allen screws
• Installation guide (This document)
Note: Use the Allen key (3 mm) supplied with the
Asetek SimSports® Invicta® Brake & Throttle
Step 1:
Notice: do not use a power drill, as this may
damage the screws
Remove pedal face plate from the throttle
pedal arm by unscrewing the screws using
the allen key, supplied with the Asetek SimSports® Invicta® Brake & Throttle.
Step 2:
Align the footrest’s holes with the pedal face
plate’s holes on the right side of the pedal
face plate.
Note: The throttle footrest is intended to be used
solely on the right side of the throttle pedal face plate
Step 3:
Insert and fasten the three allen screws with
the allen key, to mount the throttle footrest
to the pedal face plate
Note: The screws can bite hard, so be careful not to
overtighten or have the tool slip. Recommended
torque: 2nm
Step 4:
Align the pedal arm’s holes with the pedal
face plate’s holes.
Note: When the throttle footrest is mounted to
the throttle face plate, the face plate can only be
mounted in the holes, matching the colors between
the pedal face plate and the pedal arm.
Step 5:
Insert and fasten the screws with an
allen key.
Start racing!
