int_img

Support

How can we help you

search

Invicta™ – Connecting to your PC

In our relentless quest to make your experience as seamless and
immersive as possible, we have gone to great lengths to simplify
this process, too.

You will find a little dark-tinted plastic cover behind the throttle
on your Invicta™ pedals. This houses the PCB for your entire pedal
set (and your clutch, too, should you decide to add one). We
have opted for a single USB Type-C interface to make things
simple to connect and maintain

When installing your pedals, you will find that the USB Type-C
female connector is pointing towards the throttle, not towards
the pedal set’s rear. This was a very intentional choice on our side
to make sure you will not coincidentally break the connector.
Note also the small cable clip on the top of the cover. We want
to make sure that your cable is not strained and suggest you use
the provided clip to alleviate any potential strain on the cable.

Connecting is now a simple task.
If you connect directly to your PC, we recommend using the
USB Type-C to USB Type-A cable.
Plug the Type-C end into your pedals and the Type-A end into
your PC. Your PC will recognize the Asetek SimSports® Invicta™
pedals. Proceed to install RaceHub™ and configure your pedals to
your liking (See section 5 for instructions).
If you connect an Asetek SimSports® Direct-Drive wheelbase, we
suggest using the USB Type-C to USB Type-C cable, to connect
your pedals directly to your wheelbase.
Plug one end into your pedals and the other into your
wheelbase. Open RaceHub™ and configure your pedals to your
liking

simsports

submit a request

Optional